Precautions for the use of water pumps

1.if the pump has any small faults remember not to let it work. If the pump shaft packing finish wear and tear to be added in time, if you continue to use the pump will leak. The direct effect of this is to increase the energy consumption of the motor and will damage the impeller.

2. if the pump in the use of the process of strong vibration must stop to check what is the reason, otherwise the same will cause damage to the pump.

3.when the pump bottom valve leakage, some people will use dry soil into the pump inlet pipe, water to the bottom valve, this practice is not desirable. Because when the dry soil into the inlet pipe when the pump starts to work these dry soil will enter the pump, then it will damage the pump impeller and bearings, this shortens the life of the pump. When the bottom valve leakage must be taken to the maintenance, if it is very serious that need to be replaced with a new one.

4.the pump must pay attention to maintenance after use, for example, when the pump is used up to put the water in the pump clean, it is best to remove the water pipe and then rinse with water.

5.the tape on the water pump should also be removed, and then rinsed with water to dry in the light, do not put the tape in a dark and damp place. The tape of the water pump must not be stained with oil, not to mention the tape coated with something sticky.

6.to carefully check whether there is a crack on the impeller, impeller fixed in the bearing is loose, if there is a crack and loose phenomenon should be repaired in a timely manner, if the pump impeller above the soil should also be cleaned up.